HBM MP85A - Overview of All Groups and Parameters

Starting up/Setup mode
MP85A A0293_06_E00_03 HBM: public 59
7.1.2 Overview of all groups and parameters
Up
Down
SET
+
-
List of parameters
Groups
+
-
CAN BUS ETHERNET PROFIBUS
ADDITIONAL
FUNCTION
SYSTEM
STATE
Baud rate MAC address Address
Ampl.Type
(amplifier type)
S-Status
Save
Address IP-Adr.1 Main GRP
PrgVers
(firmware version)
S-Status
Restore
Main GRP IP-Adr.2
SrNo
(serial number)
S-Status
Load-Com
IP-Adr.3
HW vers.
(hardware
version)
Main GRP
IP-Adr.4 SD/MMCLo
SubNetM1
(subnet mask)
Main GRP
SubNetM2
SubNetM3
SubNetM4
IPGatew1
IPGatew2
IPGatew3
IPGatew4
Main GRP
Main GRP: Press SET to return to group
SD/MMCLo:
Gives you the option of importing a parameter set (XML format only) that was
previously saved on the MMC/SD card using the PME Assistant or INDUS
TRYmonitor. Use keys
+
and
-
to select the required parameter set.