Starting up/Setup mode
58 A0293_06_E00_03 HBM: public MP85A
The firmware update program is available on the system CD or can be down
loaded from the HBM website.
We recommend saving the device settings (device backup) before an update.
8. Device backup
All MP85A process controller settings can be saved to the MMC/SD card via
the integrated keyboard and then transferred to another MP85A process
controller, for example.
Via the device menu, you can save all 31 flash parameter sets, including all
interface settings of the MP85A process controller, as a backup (“S-Status
Save”) on the memory card, then re-import them onto the MP85A process
controller if necessary. For importing, you can choose whether to do this
without interface parameters (“S-Status Restore”) or with interface settings
(“S-Status Load-Com”) (see section 7.1.3). Confirm the action by pressing the
SET key. Progress is shown in % on the device display.
Important
No measurements or evaluations take place during device backup and the
device takes longer to respond to the software and control systems!
To Next Page
Loading...
