HBM MP85A - Page 67

Starting up/Setup mode
MP85A A0293_06_E00_03 HBM: public 67
► If several MP85A process controllers are connected to the CAN network,
make sure that each address has only been used once. If you do not know
the settings, you can find them out using the keyboard of the MP85A
process controller (see section 7.1.2).
► Click the “Save” button. The PME Assistant now searches for devices con
nected to the CAN network and includes them in the device list.
► Use the “Start” button to launch the PME Assistant.
Tip
For more information, see the online help of the PME Assistant or INDUSTRY
monitor programs.