HDG Pelletmaster 15 - Selecting the Hydraulic System

5 Commissioning the system – Procedure
103
6. Confirm this with the Enter button.
✓ The output of the boiler is set.
D
ISPLAY LANGUAGE
SETTING
7. Press the Down button until you reach the parameter Language
1-24.
✓ You are now in the submenu Language 1-24.
8. Press the Enter button.
9. Use the Plus or Minus button to select the required display
language.
10.Press the Enter button.
✓ The display language is selected.
SELECTING THE HYDRAULIC SYSTEM
1. Simultaneously press the Plus and Enter buttons.
✓ The display will change to the service level.
2. Using the Down button, select the parameter group “8-
Hydraulic system”.
3. Press the Enter button.
✓ The display will change to the parameter Hydraulic system
8-01.
✓ The cursor flashes on zero.
4. Use the Plus or Minus button to select the installed hydraulic
system.
✎ For an overview of the given hydraulic systems, see chaper
“4 Planning and installation”, section “4.10 HDG hydraulic
systems”.
Enter
No. Display Description
1-24 Language
|German |
French
• The desired display language can be selected.
Table 5/4 - Service level / 1 General
Enter
Enter
Enter
No. Display Description
8-01 Hydraulic system
Hydraulic system
(0) 0
• The installed hydraulic system can be selected.
Table 5/5 - Service level / 8 Hydraulic system