46
4.4 Installing the heating system
The heating system will initially be commissioned by specialists from
HDG Bavaria or from an authorised HDG partner and a qualified
electrician.
INSTALLING THE BOILER
1. Remove the packaging from the boiler.
2. Undo the four hexagon head bolts with which the boiler is fixed to
the pallet.
3. Transport the boiler using suitable lifting equipment.
Danger!
Risk of material damage and injury due to incorrect installation!
Installing the heating system requires comprehensive specialist
knowledge. If installed by untrained persons, the heating system
can be damaged and persons may be injured due to secondary
damage.
Only allow authorised specialists to perform the installation.
Danger!
Danger from electrical current or voltage!
Switch off the power supply and isolate the mains cable to the
heating system during the installation.
Danger!
Dust explosion due to build up of static charge!
Only qualified electricians certified according to TRBS 1203-1 may
perform work on electrical systems in areas at risk of explosion.
Caution!
Danger of injury!
Some of the components being installed are heavy. Hands and feet
could be crushed if installation is not performed properly.
All the required screws have already been bolted onto the
individual components at the corresponding positions.
Remove the screws before installing the individual components.
To Next Page
Loading...