167
9.2 Disposal
The following components are made of steel and can be recycled via
a local recycling centre.
• Boiler
• Cladding
• Intermediate pellet container
• Stoker auger without motor
• Transfer station without motor
• Delivery system
• Pressure relief baffle
• Sloping floor supports
The electrical components can also be recycled via the local recycling
centre.
Fibreglass, mineral wool and plastic parts such as suction hoses etc.
should be handed in to the respective waste disposal centres.
The geared motors used consist largely of materials which can be
recycled. If a geared motor cannot be handed over complete to a
suitable company for proper disposal, proceed as follows:
1. The gear oil must be drained into a suitable container.
2. The geared motor should be dismantled into its separate
components and cleaned if necessary.
3. Metal parts should be recycled.
Oily or greasy components and condensers may only be disposed
of through a specialist waste disposal centre.
To Next Page
Loading...