HDG Pelletmaster 15 - Page 108

5 Commissioning the system – Procedure
108
2. Press the Enter button.
3. Using the Down button, select the parameter group “General
1-06”.
4. Press the Enter button.
✓ The cursor flashes on zero.
5. Increase the value to 1 with the Plus button.
6. Press the Enter button.
✓ The settings for the initial commissioning are saved and can be
reloaded at any time if lost by calling up the parameter General
1-07.
✓ The setting of the parameters is completed.
Enter
No. Display Description
1-06 General
Operating parameters
save
(0) 0
• The set operating parameters can be saved.
Table 5/6 - Saving operating parameters
Enter
Enter