148
Enter Stored
Data Password
123ABC
4
3
2
FIGURE 7-2
Only displayed if the Operator ID
requirement is set to “Not used” (see 3.4.1
General Settings).
c) Enter the Password (default value is
“0000”) for protected functions, either
directly on the Display via the Text
mode(2) and Numeric mode(3) buttons,
or with the Barcode Scanner via the
Barcode Scanner button(4).
d) If the incorrect password is entered,
FIGURE 7-3 will be displayed.
If the correct password is entered FIGURE
7-4 will be displayed.
2 Text mode button
3 Numeric mode button
4 Barcode Scanner button
Stored Data
Incorrect
Password or User
Level
No Changes to the
Stored Data will be
Saved
6
5
FIGURE 7-3
e) Pressing the Previous image button
returns the user to FIGURE 7-2 and
allows entry of the correct password.
By pressing the Confirm button Stored
Data can be viewed, but not changed.
FIGURE 7-4 will be displayed.
If the password is not correct, and the
Confirm button is pressed, the user can
make changes, but the changes will not be
saved in the Analyzer.
5 Previous image button
6 Confirm button
To Next Page
Loading...
Need help?
General
