Click the Device on the menu bar to enter the Device Management interface:
Figure 8. 7 Device Management interface
Adding a Device
You can add a device by manually or by SADP software.
Normal Mode:
1. Click to enter the Add Devices interface.
2. Select the Type to Single or Batch.
Single IP: add single device each time.
Batch IP: add multiple devices located in the same network segment.
Figure 8. 8 Adding a Device
3. Enter the device IP for Single IP mode, or the Start IP and the End IP for the Batch IP mode.
The start IP and the end IP must be within the same network segment.
4. Enter the Username and Password for login.
5. Click Add to add the device (s).
To Next Page
Loading...
