DS-77xxNXI-I4/16P/4S NVR User Manual
UM DS-77xxNXI-I4/16P/4S 050619NA 116
Chapter 12 VCA Event Alarm
The device supports receiving VCA detections sent by connected IP cameras. Enable and configure the
VCA detection on the IP camera settings interface first.
VCA detections must be supported by the connected IP camera.
Refer to the network camera user manual for detailed VCA detection instructions.
12.1 Human Body Detection
Human body detection detects human bodies appearing in the monitoring scene, and captures the human
body pictures.
This feature is available only when the connected camera supports human body detection.
1. Go to System > Event > Smart Event.
2. Click Human Body.
3. Select the camera for which to configure human body detection.
4. Check Save VCA Picture to save the captured human body detection pictures.
5. Check Target of Interest (Human Body) to discard non-human body pictures and videos that are not
triggered by human body detection.
6. Set detection area.
1) Select the detection area to configure from the Area drop-down list. Up to eight detection areas
are selectable.
2) Check the Enable Area checkbox to enable the selected detection area.
3) Edit the area name in the Scene Name field. The scene name can contain up to 32 characters.
To Next Page
Loading...
