HIKVISION DS-7716NXI-I4/16P/4S - Configure NTP; Configure SNMP

DS-77xxNXI-I4/16P/4S NVR User Manual
UM DS-77xxNXI-I4/16P/4S 050619NA 147
Contact your Internet service provider (ISP) for details about PPPoE service.
16.5 Configure NTP
Purpose
Connection to a network time protocol (NTP) server can be configured on your device to ensure the
accuracy of system date and time.
1. Go to System > Network > TCP/IP > NTP.
Figure 16-8 NTP Settings
2. Check Enable.
3. Configure NTP settings as need.
•
Interval (min): Time interval between two time synchronization with NTP server.
•
NTP Server: IP address of the NTP server.
•
NTP Port: Port of the NTP server.
4. Click Apply.
16.6 Configure SNMP
Purpose
You can configure SNMP settings to get device status and parameter information.
Before You Start
Download the SNMP software to receive device information via the SNMP port. By setting the trap address
and port, the device is allowed to send alarm events and exception messages to the surveillance center.
1. Go to System > Network > Advanced > SNMP.