HIKVISION DS-7716NXI-I4/16P/4S - Call a Pattern; Set Linear Scan Limits

DS-77xxNXI-I4/16P/4S NVR User Manual
UM DS-77xxNXI-I4/16P/4S 050619NA 62
2) Click corresponding buttons on the control panel to move the PTZ camera.
3) Click Stop to stop recording. The PTZ movement is recorded as the pattern.
5. Repeat steps 3-4 to set more patterns.
6.3.6 Call a Pattern
Purpose
Follow this procedure to move the PTZ camera according to the predefined patterns.
1. Click on the quick settings toolbar of the PTZ camera live view. The PTZ control panel displays on
the right of the interface.
2. Click Pattern to configure pattern.
Figure 6-13 Pattern Configuration
3. Select a pattern in the text field.
4. Click Call to call it.
5. (Optional) Click Stop to stop calling it.
6.3.7 Set Linear Scan Limits
Before You Start
Make sure the connected IP camera supports the PTZ function and is properly connected.
Purpose
Enable Linear Scan to trigger a scan in the horizontal direction in the predefined range.
This function is supported by certain models.
1. Click on the quick settings toolbar of the PTZ camera live view. The PTZ control panel displays on
the right of the interface.
2. Click the directional buttons to wheel the camera to the location where you want to set the limit, and
click Left Limit or Right Limit to link the location to the corresponding limit.
The dome starts the linear scan from the left limit to the right limit, and you must set the left limit to the