HIKVISION DS-7716NXI-I4/16P/4S - Region Entrance Detection

DS-77xxNXI-I4/16P/4S NVR User Manual
UM DS-77xxNXI-I4/16P/4S 050619NA 123
if the percentage is 50%, if an object enters the region and occupies half of the whole region,
the device will trigger an alarm. Its range is [1-100].
3) Click Draw Region and draw a quadrilateral in the preview window by specifying four vertexes of the
detection region.
8. Draw the maximum size/minimum size for targets. Only targets the size of which range from maximum
to minimum will trigger intrusion detection.
1) Click Max. Size/Min. Size.
2) Draw an area in the preview window.
3) Click Stop Drawing.
9. Set the arming schedule. Refer to Chapter 11.1 Configure Arming Schedule .
10. Set the linkage actions. Refer to Chapter 11.2 Configure Alarm Linkage Actions .
11. Click Apply.
12.6 Region Entrance Detection
Purpose
Region entrance detection detects objects that enter a pre-defined virtual region.
1. Go to System Management > Event Settings > Smart Event.
2. Click Region Entrance Detection.