DS-77xxNXI-I4/16P/4S NVR User Manual
UM DS-77xxNXI-I4/16P/4S 050619NA 142
15.2 Configure POS Alarm
Purpose
The POS event can trigger channels to start recording or trigger full screen monitoring, audio warning,
notify the surveillance center, send e-mail, etc.
1. Go to Storage > Recording Schedule.
2. Set the arming schedule of the POS event.
3. Go to System > POS Settings.
4. On the POS adding or editing interface, click the Event Linkage tab.
5. Select the normal linkage actions: Full Screen Monitoring, Audio Warning, or Send E-mail.
6. Select one or more alarm output(s) to trigger.
7. Select one or more channels to record or become full-screen monitoring when a POS alarm is triggered.
Figure 15-8 Set POS Trigger Cameras
8. Click Apply to save the settings.
To Next Page
Loading...
