HIKVISION DS-7716NXI-I4/16P/4S - Configure Esata for Data Storage; Storage Mode; Configure HDD Group

DS-77xxNXI-I4/16P/4S NVR User Manual
UM DS-77xxNXI-I4/16P/4S 050619NA 67
Result
Return to the HDD Information menu after adding the IP SAN disk. The added NetHDD will display in the list.
If the installed HDD or NetHDD is uninitialized, select it and click the Init button for initialization.
7.1.3 Configure eSATA for Data Storage
When there is an external eSATA device connected to the device, you can configure the eSATA for data
storage and manage the eSATA in the device.
1. Click Storage > Advanced.
2. Set the eSATA type to Export or Record/Capture from the drop-down eSATA list.
•
Export: Use the eSATA for backup.
•
Record/Capture: Use the eSATA for record/capture. Refer to the following steps for instructions.
Figure 7-3 Set eSATA Mode
3. When the eSATA type is selected to Record/Capture, enter the storage device interface.
4. Edit the property of the selected eSATA, or initialize it as required.
7.2 Storage Mode
7.2.1 Configure HDD Group
Purpose
Multiple HDDs can be managed in groups. Video from specified channels can be recorded onto a particular
HDD group through HDD settings.
1. Go to Storage > Storage Device.
2. Check the checkbox to select the HDD to set the group.
Figure 7-4 Storage Device