DS-77xxNXI-I4/16P/4S NVR User Manual
UM DS-77xxNXI-I4/16P/4S 050619NA 74
6. Repeat the above steps to schedule recording or capture for other days in the week.
7. Click Apply to save the settings.
To enable Motion, Alarm, M | A (motion or alarm), M & A (motion and alarm), and Event triggered recording
and capture, you must configure the motion detection settings, alarm input settings, and other events as
well. Refer to
Chapter 11 Event and Alarm Settings
and
Chapter 12 VCA Event Alarm
for details.
7.5 Configure Continuous Recording
1. Go to Camera > Encoding Parameters > Recording Parameters.
2. Set the continuous main stream/sub-stream recording parameters for the camera.
3. Go to Storage > Recording Schedule.
4. Select Continuous for recording type.
5. Set the schedule for the continuous recording. Refer to
Chapter 7.4 Configure Recording Schedule
for
details.
7.6 Configure Motion Detection Triggered Recording
You can configure the recording triggered by a motion detection event.
1. Go to System > Event > Normal Event > Motion Detection.
2. Configure the motion detection and select the channel(s) to trigger the recording when a motion event
occurs. Refer to
Chapter 11.3 Configure Motion Detection Alarm
for details.
3. Go to Camera > Encoding Parameters > Recording Parameters.
4. Set the event main stream/sub-stream recording parameters for the camera.
5. Go to Storage > Recording Schedule.
6. Select Motion recording type.
7. Set the schedule for the motion detection triggered recording. Refer to
Chapter 7.4 Configure
Recording Schedule
for details.
7.7 Configure Event Triggered Recording
You can configure recordings triggered by motion detection, vehicle detection, line crossing detection,
etc.
1. Go to System > Event.
To Next Page
Loading...
