Hill-Rom Basic Care P1440 - Chapter 4: Removal, Replacement, and Adjustment Procedures; Tool and Supply Requirements

Basic Care™ Bed Service Manual (man336) Page 4 - 1
4
Chapter 4
Removal, Replacement, and
Adjustment Procedures
Tool and Supply Requirements
To service the Basic Care™ Bed, the following tools and supplies are
necessary:
• Phillips head screwdriver
• Screwdriver
• Small screwdriver
• 13 mm socket
• 17 mm socket
• Ratchet
• 8 mm nut driver, deep well
• 13 mm nut driver
• 6 mm wrench
• 8 mm wrench
• 17 mm wrench
• 2.5 mm Allen™
1
wrench
• 3 mm Allen™ wrench
• 4 mm Allen™ wrench
• 4 mm T-handle Allen™ wrench
• 5 mm Allen™ wrench
• 8 mm Allen™ wrench
• 10 mm Allen™ wrench
1. Allen™ is a trademark of Industrial Fasteners, Inc.