Hill-Rom Basic Care P1440 - Control Panel, Foot End; Removal

4.2 Control Panel, Foot End
Chapter 4: Removal, Replacement, and Adjustment Procedures
Basic Care™ Bed Service Manual (man336) Page 4 - 5
4
4.2 Control Panel, Foot End
Tools required: Phillips head screwdriver
Wire cutters
Removal
SHOCK HAZARD:
Disconnect the bed from its power source. Failure to do so could result
in personal injury or equipment damage.
1. Disconnect the bed from its power source.
2. Make a note showing the cable routing from the foot end control panel (A)
to the control box assembly (B) (see figure 4-2 on page 4-5).
Figure 4-2. Foot End Control Panel Assembly