Bed Frame Features
44 Progressa™ Bed User Manual (171528 REV 1)
To store the transport handles:
1. Grasp the handles, and lift upwards to unlock the handles.
2. Swing the handles inward toward the center of the bed into the
stowed position.
In case of battery or motor power loss, press the
electronic brake switch (on the drive box on the
bottom of the bed) to permit forward and reverse
bed movement with a deployed, unpowered,
IntelliDrive® Transport System.
WARNING:
If the bed propels forward or reverse when
depressing one of the enable switches and
not applying any pressure on either of the handles, contact your local service personnel for repair.
Failure to do so can cause injury or equipment damage.
WARNING:
If the bed propels forward or reverse while applying pressure on either of the transport handles
and not pressing either of the enable switches, contact your local service personnel for repair.
Failure to do so can cause injury or equipment damage.
WARNING:
If the bed is stopped on a ramp, or a patient is left unattended, set the brake to avoid unwanted
bed movement. Failure to do so can cause injury or equipment damage.
WARNING:
Significantly reduce the speed of travel when powering the IntelliDrive® Transport System when
using freestanding patient attached equipment or traveling through doorways. Failure to do so can
cause injury or equipment damage.
CAUTION:
The IntelliDrive® Transport System is intended for indoor use only. Outdoor use may cause
temporary or permanent damage to the powered drive mechanism and/or drive belt.
To Next Page
Loading...
