WARNING Electric shock hazard. Do not open the monitor or attempt repairs. The
monitor has no user-serviceable internal parts. Only perform routine cleaning and
maintenance procedures specifically described in this manual. Inspection and
servicing of internal parts shall only be performed by qualified service personnel.
CAUTION Sterlizing the monitor could damage the device.
1. Disconnect the AC power cord from the mains outlet.
2. Wipe the top of the monitor.
3. Wipe the sides, front, and rear of the monitor.
4. Avoid residual film buildup on the LCD screen. After cleaning and disinfecting, wipe the LCD
screen with a clean cloth dampened with water, and then wipe the screen dry with a dry clean
cloth.
5. Wipe the bottom of monitor.
6. Wipe the APM work surface.
7. Wipe the accessory bins or basket.
8. Wipe the AC power cord and the APM work surface power/USB cable assembly.
9. Wipe the stand from top to bottom.
Dry the equipment
1. Allow all components except the LCD screen to air dry.
2. Wipe the LCD screen dry with a clean cloth.
Store the device
Store the device according to facility guidelines to keep the device clean, dry, and ready for
service.
Cleaning accessories
Accessories include components like blood pressure cuffs and hoses, SpO2 sensors and cables,
thermometers, and the barcode scanner. Follow accessory manufacturer’s instructions for cleaning
and disinfection.
For cleaning the wallboard and VESA mount, use only 70 percent isopropyl alcohol solution applied
to a clean cloth.
For the Braun ThermoScan PRO 6000 thermometer, use only the approved cleaning agents
published in the manufacturer's instructions for cleaning. Unapproved cleaning agents can
damage the device and interfere with data transmission.
Clean the Braun ThermoScan PRO 6000 contacts
Debris that accumulates on the Braun ThermoScan PRO 6000 electrical contacts can interfere with
data transmission. Welch Allyn recommends cleaning the contacts on the thermometer and the
dock once every 4 months to maintain optimal performance.
100 Cleaning requirements Welch Allyn® Connex® Spot Monitor
To Next Page
Loading...
Need help?
General
