Hillrom Welch Allyn Connex Spot Monitor Service Manual

Name: Hillrom Welch Allyn Connex Spot Monitor
Brand: Hillrom
Rating: 5 (1 reviews)

265 pages

To Next Page

To Previous Page

Remove the back housing

1. Remove the 6 Phillips screws on the back of the device to remove the back housing.

2. Lift the back housing straight up off the device.

3. Remove end cap on the right by pulling it out of its slot.

Service manual Disassembly and repair 51

Table of Contents3
Symbols and Definitions7
Safety11
Warnings and Cautions11
General Safety Considerations12
Electrostatic Discharge (ESD)12
Overview15
Purpose and Scope15
Technical Support Services16
Recommended Service Intervals20
The Welch Allyn Service Tool21
Battery Performance22
Controls, Indicators, and Connectors25
Advanced Settings29
Access Advanced Settings29
General Tab30
Parameters Tab31
Network Tab32
Service Tab37
Power-Up Sequence41
Bluetooth Wireless Technology43
Enable Bluetooth Pairing43
Pair a Device with Bluetooth Wireless Technology43
Bluetooth Low Energy (BLE) Workflow45
Disassembly and Repair47
Required Tools and Equipment48
Torque Value Table48
Connector Types49
Disassembly Overview52
Power down the Monitor53
Remove the Monitor from the Stand54
Exploded View Diagram55
Remove the Battery56
Remove the Back Housing57
Remove the Temperature Module or Housing58
Disassemble the Main PCA Board61
Remove the Speaker61
Separate the Main PCA Board from the Front Housing62
Remove the Spo2 Insert63
Remove the Spo2 Board67
Remove the Communications Board70
Board72
Remove the Pump Assembly77
Replace the Main PCA Board78
Disassemble the Front Housing79
Remove the Bezel from the Front Housing79
Accessory Power Management (APM) Work Surface80
Remove the APM Work Surface from the Stand80
Remove the APM Work Surface Battery81
Disassembly and Assembly Notes for Mobile Stands and Power Supplies83
Field Replaceable Units95
Device Serial Number and Model Label97
About 4Th Edition Service Kits97
About 3Rd Edition Service Kits98
Cleaning Requirements103
Prepare to Clean the Equipment103
Remove Liquid Spills from the Monitor105
Clean the Equipment105
Dry the Equipment106
Store the Device106
Cleaning Accessories106
Clean the Braun Thermoscan PRO 6000 Contacts106
Decontamination and Cleaning Requirements for Returns107
Device Configuration and Setup109
Configuration Overview109
Functional Verification and Calibration Overview113
Functional Verification Tests113
Basic Functional Verification117
Full Functional Verification and Calibration126
Options and Upgrades131
Available Options132
Install Options133
Upgrading Software with the Welch Allyn Service Tool133
Upgrade the Device Firmware134
Smartcare™ Services for Maintenance and Repair134
Service and Repair Training136
Appendix137
Specifications137
Factory Defaults148
Install the Nurse Call Cable158
Configure a Remote VNC Connection158
Troubleshooting161
Interpreting Log File Output161
Symptoms and Solutions166
Technical Alarm and Information Messages177
Connex Direct223
Introduction223
Active Directory Setup227
Project Workflow248
Troubleshooting248
Identifying the Monitor and Subsystems255
Monitor Serial Number and Model Label255
Monitor Circuit Board and Internal Options Label255
Model Number Format and Code256
Interconnect Diagram258
Service and Maintenance Toolset259
Service Software IT Setup261
Service Record263

Hillrom Welch Allyn Connex Spot Monitor Service Manual

Table of Contents

Questions and Answers:

Hillrom Welch Allyn Connex Spot Monitor Specifications

Related product manuals

Brand	Hillrom
Model	Welch Allyn Connex Spot Monitor
Category	Medical Equipment
Language	English