Hioki 3158 - Page 108

96
────────────────────────────────────────────────────
7.4 Command
────────────────────────────────────────────────────
Sets the test time.
Syntax
:CONF:TIM <data>
data
0.5 - 99.9 ( Numerical data in NR2 format, two or three digits )
100 - 999 ( Numerical data in NR1 format, three digits )
Test time ( Refer to section 7.5. )
Response
OK
Function
In the READY or SETTING state, set the test time.
Example
Sets the test time to 1.0 s.
Example
PC
>
3158
>
:CONF:TIM 1.0
OK Setting completion.
Error
The execution of this command in a state other than the READY and SETTING state
causes an execution error.
Queries the test time.
Syntax
:CONF:TIM?
Response
<data>
data
Test time ( Refer to section 7.5. )
Function
Queries the test time.
Example
PC
>
3158
>
:CONF:TIM?
1.0 Test time is 1.0 s.
:CONF:TIM
:CONF:TIM?