Hioki 3158 - Page 42

30
────────────────────────────────────────────────────
3.3 Setting the "SETTING" State
────────────────────────────────────────────────────
(2) Setting the comparative-voltage value
The comparative-voltage value is initially set to OFF. It must be changed to ON
before the value is changed. To do so, press the
ON/OFF
key.
The comparative-voltage value in the OFF state is displayed. In this example,
the value is 1.50 kV.
Using the
/ keys, set the comparative voltage value to 2.00 kV.
To change the value by 0.01 kV, press
/ keys.
To change the value by 0.10 kV, press
SHIFT
+ / keys.
(3) Setting an upper-level value
Press the
key to move the flashing cursor to the upper-level value.
In this example, switch from 120 mA to 20 mA using the
/ keys.
To change the upper level value by 1 mA, press
/ keys.
To change the upper level value by 10 mA, press
SHIFT
+ / keys.
(4) Setting a lower-level value
Using the
key, move the flashing cursor to the lower level value.