Hioki BT3564 - Page 131

8.6 Message Reference
125
8
Chapter 8 RS-232C/GP-IB Interfaces
Set and Query the Auto-Ranging Setting
Syntax
Command
:AUTorange <1, 0, ON or OFF>
Query
:AUTorange?
Response <ON or OFF>
Example
Command
:AUT ON
Note
• Attempting to enable auto-ranging when the Comparator or Memory function is
enabled results in a execution error.
• The auto-ranging setting applies to both resistance measurement and voltage
measurement.
Cancel Zero-Adjustment
Syntax
Command
:ADJust:CLEAr
Description
Command Clears zero adjustment.
Execute Zero Adjustment and Query the Result
Syntax
Query
:ADJust?
Response <0/ 1 (NR1)>
0....... Zero adjustment succeeded
1....... Zero adjustment failed
The acceptable range of zero adjustment for both resistance
and voltage is from -1000 to +1000 dgt.
Description
Query Queries whether zero adjustment has succeeded or failed.
Example
Query
Response
:ADJ?
0
Zero adjustment executed successfully.
Note
Zero-adjust processing may take time. Either allow an interval to elapse before
receiving the response data or set the timeout time to about 10 sec.
Select and Query the Sampling Rate setting
Syntax
Command
:SAMPle:RATE <FAST/ MEDium/ SLOW>
Query
:SAMPle:RATE?
Response <FAST/ MEDIUM/ SLOW>
Example
Command
:SAMP:RATE MED
Query
Response
:SAMP:RATE?
MEDIUM
HIOKI BT3564A961-02