Intended audience
This document is intended for system administrators, Hitachi Data Systems
representatives, and authorized service providers who install, configure, and
operate the Hitachi Virtual Storage Platform G1000 storage system.
Readers of this document should be familiar with the following:
• Data processing and RAID storage systems and their basic functions.
• The VSP G1000 storage system and the Hitachi Virtual Storage Platform
G1000 Hardware Guide.
• The Command Control Interface software.
• The Hitachi Command Suite (HCS) software.
Product version
This document revision applies to VSP G1000 microcode 80-02-0x or later.
Release notes
The Hitachi Virtual Storage Platform G1000 Release Notes are available on
the Hitachi Data Systems Portal:
https://portal.hds.com. Read the release
notes before installing and using this product. They may contain
requirements or restrictions that are not fully described in this document or
updates or corrections to this document.
Document revision level
Revision Date Description
MK-92RD8072-00 August 2014 Initial release
MK-92RD8072-01 October 2014 Supersedes and replaces MK-92RD8072-00
Changes in this revision
• Added descriptions to Planning physical paths on page 3-4.
• Added descriptions to Relationship between the quorum disk and number
of remote connections on page 3-11.
• Migration volumes can be used as GAD pair volumes. See
Requirements
and restrictions on page 2-2.
Referenced documents
Hitachi Virtual Storage Platform G1000 documentation:
x
Preface
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide
To Next Page
Loading...
