Hitachi G1000 - 4 Configuration and pair management using CCI

4
Configuration and pair management
using CCI
This chapter describes and provides instructions for using CCI commands to
configure a global-active device system and manage GAD pairs.
□
Global-active device system configuration
□
Workflow for creating a GAD environment
□
Initial state
□
Adding the external system for the quorum disk
□
Verifying the physical data paths
□
Creating the command devices
□
Creating the configuration definition files
□
Starting CCI
□
Connecting the primary and secondary storage systems
□
Creating the quorum disk
□
Setting up the secondary system
□
Updating the CCI configuration definition files
□
Creating the GAD pair
Configuration and pair management using CCI
4-1
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide