Hitachi G1000 - Creating Additional Host Groups in a VSM

0x4444 -virtual_ldev_id reserve -IH1). After releasing the reservation
attribute, use the check command to confirm that fffe is displayed for
VIR_LDEV (virtual LDEV ID).
Creating additional host groups in a VSM
Create a host group to be used by the S-VOL of the GAD pair. If necessary,
set the host mode for the host group.
Note:
• Host group 0 exists by default. You need to create a host group only if
you are creating additional host groups with host group ID 1 or higher.
• If you create a new host group but do not reserve the new host group ID
in the resource group, add the new host group ID to the resource group
as described in
Reserving a host group ID on page 4-29.
Procedure (for CL1-C-1)
1. Create a host group (HAVol) with host group ID 1 on port (CL1-C).
raidcom add host_grp -port CL1-C-1 -host_grp_name HAVol -IH1
Configuration and pair management using CCI
4-35
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide