Hitachi G1000 - Setting up a global-active device environment

Setting up a global-active device environment
After the HCS management server has discovered resources, you can use the
Set up Global-Active Device window for setup tasks that must be
performed before global-active device pairs can be allocated.
About global-active device setup
The global-active device setup window provides a workflow for configuring
required storage system resources before global-active device paired volumes
can be allocated.
Access to the global-active device setup window is provided from:
• The Actions menu on the global task bar
• The Replication tab, from General Tasks
The setup window provides access to various HCS or Replication Manager
dialog boxes. As tasks are completed, or if tasks have already been
completed by other procedures, the setup window identifies completed tasks
and provides a link to configuration details. If you close the setup window and
reopen it later, the completed tasks remain identified.
5-2
Using Hitachi Command Suite to set up global-active device
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide