Hitachi G1000 - Page 131

The following figure depicts the setup window configuration items in the
global-active device environment:
•
Select Storage Systems (see below). This task must be done first.
The following setup tasks can be performed in any order, but must be
completed before you can allocate global-active device pairs.
•
Configure Remote Paths (see
)
•
Configure Quorum Disks (see
)
•
Configure Pair Management Servers (see )
•
Configure Virtual Storage Machines (see
)
Related topics
• Prerequisites for global-active device setup using HCS on page 5-4
• Select primary and secondary storage systems on page 5-4
• Configuring remote paths on page 5-5
• Configuring the quorum disk on page 5-6
•
Configuring pair management servers on page 5-8
• Configuring the virtual storage machine on page 5-9
Using Hitachi Command Suite to set up global-active device
5-3
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide