localhost 31001 -1 3000
HORCM_CMD
\\.\PhysicalDrive1
HORCM_LDEV
#GRP DEV SERIAL LDEV# MU#
oraHA dev1 322222 44:44 0
HORCM_INST
#GPR IP ADR PORT#
oraHA localhost 31000
Restarting CCI
After editing the configuration definition files, restart both CCI instances.
Procedure (Windows shown)
Start instances 0 and 1.
horcmstart 0 1
starting HORCM inst 0
HORCM inst 0 starts successfully.
starting HORCM inst 1
HORCM inst 1 starts successfully.
Creating the GAD pair
After verifying that the same virtual LDEV ID as that of the primary volume
does not exist in the virtual storage machine of the secondary site, you can
create the GAD pair.
•
Verifying the virtual LDEV ID in the virtual storage machine of the
secondary site on page 4-43
• Creating a global-active device pair on page 4-45
Verifying the virtual LDEV ID in the virtual storage machine of the
secondary site
Before creating a GAD pair, check that the same virtual LDEV ID as that of
the primary volume does not exist in the virtual storage machine of the
secondary site, which has the same serial number and model as the primary
storage system. If the same virtual LDEV ID as the primary volume exists,
you cannot create the GAD pair.
Operate the virtual storage machine to check that the virtual LDEV ID does
not exist. Specify the virtual storage machine for HORCM_VCMD of the
configuration definition file, and then start CCI.
Procedure (Windows shown)
1. Start instances (100 and 101) for confirming the virtual LDEV IDs.
Configuration and pair management using CCI
4-43
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide
To Next Page
Loading...
