EasyManua.ls Logo

Hitachi G1000 - Hitachi Command Suite; Command Control Interface; Configuration Workflow for Global-Active Device

Hitachi G1000
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Hitachi Command Suite
The Command Suite (HCS) GUI software enables you to configure and
manage GAD pairs and monitor and manage your global-active device
environment. When one Device Manager server manages both global-active
device storage systems, you can access all required functions for your GAD
setup from the HCS Global-Active Device window.
Disaster recovery procedures are performed using CCI and cannot be
performed using Command Suite.
Command Control Interface
The Command Control Interface (CCI) command-line interface (CLI) software
can be used to configure the global-active device environment and create and
manage GAD pairs. CCI is also used to perform disaster recovery procedures.
Configuration workflow for global-active device
The following table lists the global-active device configuration tasks and
indicates the location of the GUI and CLI instructions for the tasks.
Configuration task Operation target CCI HCS
Installing global-active device Primary, secondary
systems
Not available. Section on
installing a
software
application in the
Hitachi Command
Suite User Guide
Creating command devices Primary, secondary
systems
Creating the
command devices on
page 4-10
Configuring pair
management
servers on page
5-8
Creating and executing CCI
configuration definition files
Server. (With HCS,
this is the pair
management
server.)
Creating the
configuration
definition files on
page 4-11
Monitoring and
managing global-
active device pairs
on page 5-10
Connecting primary
and secondary
systems
Changing port
attributes
Primary, secondary
systems
Setting the port
attributes on page
4-13
Setting up a
global-active
device
environment on
page 5-2
Adding remote
connections
Primary, secondary
systems
Adding remote
connections on page
4-15
Creating the
quorum disk
Changing the port
attribute to
External
Primary, secondary
systems
Creating the quorum
disk on page 4-17
> Setting the port
attributes for
connecting the
external storage
system on page
4-17
Overview of global-active device
1-23
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide

Table of Contents

Other manuals for Hitachi G1000

Related product manuals