Hitachi G1000 - Reserving an LDEV ID for the S-VOL

Check command and output examples
Display information about the volume (LDEV ID: 0x4444). For the volume
whose virtual LDEV ID was deleted, fffe is displayed for VIR_LDEV (virtual
LDEV ID).
raidcom get ldev -ldev_id 0x4444 -fx -IH1
Serial# : 322222
LDEV : 4444 VIR_LDEV : fffe
SL : -
CL : -
VOL_TYPE : NOT DEFINED
SSID : -
RSGID : 0
Note: If you need to reconfigure a deleted virtual LDEV ID, use the raidcom
map resource command (example: raidcom map resource -ldev_id
0x4444 -virtual_ldev_id 0x4444 -IH1). The default virtual LDEV ID is the
same as the actual LDEV ID. After reconfiguring the virtual LDEV ID, use the
check command to confirm that the virtual LDEV ID is the same as the actual
LDEV ID.
Reserving an LDEV ID for the S-VOL
In the newly created resource group, you will reserve an LDEV ID so that the
volume is available to become the target volume of a GAD pair.
4-32
Configuration and pair management using CCI
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide