Hitachi G1000 - Creating External Volumes

raidcom get command_status -IH1
HANDLE SSB1 SSB2 ERR_CNT Serial# Description
00c3 - - 0 322222 -
Check command and output examples
1. On the primary storage system, display information about the external
path to the volume in the external storage system.
raidcom get path -path_grp 1 -IH0
PHG GROUP STS CM IF MP# PORT WWN PR LUN PHS
Serial# PRODUCT_ID LB PM
1 1-1 NML E D 0 CL5-A 50060e8007823520 1 0 NML
33333 VSP G1000 N M
2. On the secondary storage system, display information about the external
path to the volume in the external storage system. Confirm that external
system information is correct, including serial number, model, and WWN,
and confirm that the path status and volume status are normal.
raidcom get path -path_grp 1 -IH1
PHG GROUP STS CM IF MP# PORT WWN PR LUN PHS
Serial# PRODUCT_ID LB PM
1 1-2 NML E D 0 CL5-C 50060e8007823521 1 0 NML
33333 VSP G1000 N M
Creating external volumes
Using capacity in the external system, you will create virtual external
volumes on the primary and secondary systems that will be mapped to the
quorum disk.
Configuration and pair management using CCI
4-21
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide