Hitachi G1000 - Setting External Volumes as Quorum Disks

Setting external volumes as quorum disks
This section provides instructions for setting the virtualized external volumes
in the primary and secondary systems as quorum disks. The same quorum
disk ID must be set to the primary and secondary storage systems.
The serial number and model of the paired storage system is specified for the
-quorum_enable option of the raidcom modify ldev command.
Note: When specifying the serial number for VSP G1000 using CCI, add a “3”
at the beginning of the serial number. For example, for serial number 11111,
enter 311111.
Procedure
1. Specify 0 to the quorum disk ID to set the volume (0x9999) in the
primary storage system (serial number 22222, entered as 322222) as a
quorum disk. Specify the storage system's serial number and model, VSP
G1000.
raidcom modify ldev -ldev_id 0x9999 -quorum_enable 322222 R800 -
quorum_id 0 -IH0
2. Confirm that asynchronous command processing has completed.
raidcom get command_status -IH0
HANDLE SSB1 SSB2 ERR_CNT Serial# Description
00c3 - - 0 311111 -
4-24
Configuration and pair management using CCI
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide