Hitachi G1000 - Page 126

(SIM=720XXX, where XXX is the pool ID) is issued (the used capacity
exceeds the warning threshold).
Note: You cannot create a GAD pair by using instances (100 and 101) for
confirming the virtual LDEV IDs. To create a GAD pair, use instances (0 and
1) for operating storage systems.
Procedure
Specify 0 for the quorum disk ID to create a GAD pair.
paircreate -g oraHA -f never -vl -jq 0 -IH0
Check command and output examples
Confirm that a GAD pair is created.
pairdisplay -g oraHA -fxce -IH0
Group PairVol(L/R) (Port#,TID, LU),Seq#,LDEV#.P/S,Status,Fence,
%,P-LDEV# M CTG JID AP EM E-Seq# E-LDEV# R/W
oraHA dev1(L) (CL1-A-0, 0, 0)311111 2222.P-VOL PAIR
NEVER ,
100 4444 - - 0 - - - - L/M
oraHA dev1(R) (CL1-C-0, 0, 0)322222 4444.S-VOL PAIR
NEVER ,
100 2222 - - 0 - - - - L/M
4-46
Configuration and pair management using CCI
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide