d. Click Host Group and LUN settings for further configuration.
e. In Pair management Server Settings:
Select an available host as the pair management server. For Instance
ID, click Existing to use a current configuration definition file and
related instance ID number on the pair management server, or click
New to create a new configuration definition file, and enter a new
instance ID number which will be validated as an available instance
ID. You can also specify a UDP Port number for the instance.
6. On the Secondary tab, configure the following options:
a. Select the secondary Storage system, Virtual Storage Machine,
and Volume type (HDP or HDT):
Virtual storage machine information defaults to the primary tab value.
b. In Advanced options:
Unlike the Primary tab dialog, this dialog on the Secondary tab allows
you to select secondary storage system HDP pools (Pools for S-VOL )
that correspond to primary storage system HDP pools configured on
the primary tab (Pools for P-VOL). For example, automatic selection of
HDP volumes will display primary HDP pools, and eligible secondary
HDP pools for volume allocation. You can examine primary tab HDP
pool and volume details with links. You can accept the HDP pools
selected for secondary volumes, or make a manual selection by
clicking Select Pool to list and select eligible HDP pools, and selecting
eligible volumes from the HDP pools.
c. In LUN Path Options:
Edit LUN paths from secondary storage ports to hosts. Under LUN
Path Setting Information on Primary Site, you will see the
primary storage system, and No. of LUN Paths per volume. Clicking
the link will display primary storage system mapping information.
d. Click Host Group and LUN settings for further configuration.
e. In Pair management Server Settings:
Select an available host as the pair management server. For Instance
ID, click Existing to use a current configuration definition file and
related instance ID number on the pair management server, or click
New to create a new configuration definition file, and enter a new
instance ID number which will be validated as an available instance
ID. You can also specify a UDP Port number for the instance.
7. Click Virtual ID Settings for further configuration.
These settings are displayed only in a configuration where options other
than the default virtual storage machine are used on the primary side.
8. In Pair Settings:
Select the Quorum Disk, select new or existing in the Copy Group for
management purposes, and then manually enter a name (Prefix and Start
Sequence No.) or select Automatic for Pair Name and a name will be
created.
9. Click Show Plan and confirm that the information in the plan summary is
correct. If changes are required, click Back.
Using Hitachi Command Suite to set up global-active device
5-11
Hitachi Virtual Storage Platform G1000 Global-Active Device User Guide
To Next Page
Loading...
