Hitachi PXR-D - Page 120

● Setting high-speed printing 3-52
5 Set "Character orientation" to "0: ABC" or "1: ABC"
on the "Print specifications" screen.
Print specifications 2011.07.07 12:45
Character height [ ５０] (０-９９)
Character width
 [００２] (０-１９９)
Character orientation [０] (０:ＡＢＣ １:ＡＢＣ ２: ３: )
（Arrow: Printing direction） → ← ← →
Printing method ２ (1: single scan 2: Interlaced )
Repeat intervals [００００] (scanning unit SC 0-9999)
Repeat count [００００] (0: none, 1-9998, 9999: continuous)
Print start delay [００５０] (scanning unit SC 0-1234)
Target sensor timer [０００] (1/10 sec 0: none, 1-999
)
Target sensor filter [１] (1: time setup 2:until end of print. )
Setup value [００５０] (msec 0-9999)
Back
1234567890
Incre-
ment
Decre-
ment
Character
unit CH
Scanning
unit SC
ＡＢＣＡＢＣ
Manual
Show
cursor
Status: Ready Com=0
Message name
［ SAMPLE 1 ］
Start
up
Shut
down
Comm
On/Off
Prev.
set-
tings
Next
set-
tings
↑
↓
→
←
6 Press Next settings .
¡ The second page of "Print specifications" screen will appear.
Print specifications 2011.07.07 12:45
Back
1234567890
Incre-
ment
Decre-
ment
Manual
Show
cursor
Status: Ready Com=0
Message name
［ SAMPLE 1 ］
Start
up
Shut
down
Comm
On/Off
Prev.
set-
tings
Next
set-
tings
↑
↓
Product speed matching [０] (0:Time-based1:Encoderbased)
Pulse rate div. Factor [００１] (1/1〜1/999Enterdenominator.)
Ink drop use 
[ ０３] (1/1〜1/16Enterdenominator.)
High-speed print
 [０] (０:HM1:NM２：QM)
Calendar offset
 [１] (1:offsetfromyesterday２:fromtoday)
Day of week char.
 [１] (1:1-7２:A-G３:Userpattern)
→
←