Hitachi PXR-D

● Creating a User Pattern 5-10
5
4
¡ To move the cursor, press down on the matrix that is located beside
the dot pattern creation area.
¡ The procedures for moving the cursor are indicated below.
↑ key
↓ key
← key
→ key
key
←
key
←
key
←
key
←
Press ↓ on the right-hand side.
The cursor then moves to the inter-character space input field.
Press Decrement two times consecutively.
The inter-character space is then set to 0.
¡ The cursor is set at the upper left-hand corner of the pattern creation area.