Hitachi PXR-D

● Ink Drop Generation Status Checkout Procedure 7-38
7.14 Ink Drop Generation Status Checkout
Procedure
¡ When checking the ink stream position, wear protectors (safety goggles and
mask).
¡ If the ink or makeup ink should enter your eyes or mouth, immediately flush
with warm or cold water and see a physician.
¡Before ejecting the ink, ensure that there is no person in the direction of
ejection. (The end of the print head must be placed in a beaker or the like.)
WARNING
¡ The procedure set forth below must be performed during ink ejection.
1 Sequentially press the Start up key and Ready key to enter the
"Ready" state.
2 Loosen the screws, and then remove the print head cover.
3 With a magnifying glass, check how the ink drops are generated in
the charge electrode.
Checkout point
Pull out.
Loosen the screw.
Print head cover