ENGLISH
DSW1: Additional setting 0
Factory setting. No setting is required.
YUTAKI S (*)
YUTAKI S COMBI (*)
YUTAKI S80
1~ 230V 50Hz 3N~ 400V 50Hz
YUTAKI M
? NOTE
(*): In case of installing the “Cooling kit” accessory, set the pin 4 of DSW1 to ON in order to enable the cooling operation.
DSW2: Unit capacity setting
Factory setting. No setting is required.
2.0HP 2.5HP 3.0HP 4.0HP 5.0HP 6.0HP 8.0HP 10.0HP
DSW3: Additional setting 1
Setting before shipment
1-step heater for 3-phase unit
ELECTRICAL AND CONTROL SETTINGS
PMML0575 rev.2 - 03/2022
89
To Next Page
Loading...
Need help?
General
