EasyManua.ls Logo

Hitachi YUTAKI RWM-2R1E - Heat Pump Configuration

Hitachi YUTAKI RWM-2R1E
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
9.13.4.7 Heat Pump conguration
Water pump conguration:
Congure the water pump of the
heat pump.
See detailed information in the
next page.
Night shift:
Reduces compressor load in order to reduce
environmental noise, preferably at night.
See detailed information in the next page.
Minimum ON time:
In order to reduce a possible compressor damage,
demand ON cycles can be reduced by determining
the time that must pass before accepting new
Demand OFF.
Minimum OFF time:
In order to reduce a possible
compressor damage, demand OFF
cycles can be reduced by determining
the time that must pass before
accepting new Demand ON.
Seizure protection:
The pump seizure protection function
prevents sticking of components due
to long periods of inactivity, by running
the components during a short period
every week. Mixing valves and pumps
are fully opened and then fully closed
(time depends on Mixing valve Run
Time Factor).
Outdoor average temperature:
OTC average is used to neutralise the effect of
occasional temperature variations.
The average value of outdoor temperature sampled
over a selected period (between 1 and 24 hours) is
used for the calculation of weather-dependent set
point temperature.
1 / 2
2 / 2
UNIT CONTROLLER (PC-ARFH2E)
PMML0575 rev.2 - 03/2022
219

Table of Contents

Related product manuals