
• Select the bivalent point for boiler or electric backup heater (from -20 ºC to 20 ºC).
• Press OK button.

• Select Yes if fan coil can be controlled through the outputs.
• Press OK button.

• Select the type of room thermostat installed in circuit 1 or 2 (depending on the previous setting): None, wired or wireless.
• Repeat this step in case of circuit 2.
• Press OK button.

• Conguration assistant is completed.
• Press OK button to go to the main screen.
UNIT CONTROLLER (PC-ARFH2E)
PMML0575 rev.2 - 03/2022
180
To Next Page
Loading...
Need help?
General
