Hitachi YUTAKI Series - Mounting; Fitting or Removing the; Wall Mounting

Controller pack
Service Manual
110
Mounting
SMGB0066 rev.0 - 12/2009

The System Controller is designed to be mounted either directly onto the wall or on a DIN-rail.

caution
Incorrect wall mounting. Reduction of the IP protection degree. Perform the installation of the System Controller -
without damaging the unit.
 
To remove the front cover from the mounting base
Unscrew the two retaining screws 1. .
Pull the front cover off the mounting base 2. .

caution
Crash hazard. Wire damage. Make sure that all connector pins and blocks are correctly located before pushing -
the front cover onto the base, otherwise, damage may occur.
Totthefrontcoverontothemountingbase:
Line up the mounting base and front cover.1.
Pushthefrontcoverrmlyontothemountingbase.2.
Secure the front cover using the two retaining screws.3.
 
- Four 4.0 mm holes for installation are located on the System Controller mounting base for wall mounting.
- Beforewallmounting,removethefourbreak-outs(A)inthecaseasnecessary.