Hitachi YUTAKI Series - Opening Electrical Box (P-Mounting Plate)

Servicing
Service Manual
246
RHUE-(3~6)A(V)HN
SMGB0066 rev.0 - 12/2009
 

Remove the service cover according to the section 1.
“Removing the service cover” in this chapter.
Removetheve(5)screwsxingtheelectrical -
box. Open the P-mounting plate by rotating it 90
degrees to the left.

danger
Electrical hazard. Risk of death. -
Check that the LED201 (red) located on the inverter -
module is OFF when opening the P-mounting plate.
Do not touch the electrical components when LED201 -
(Red) located on the inverter module is ON in order to
avoid an electrical shock.
2 screws
1 screw
2 screws
P-Mounting plate