Hitachi YUTAKI Series - Installation Configuration Settings; Reviewing and Setting the Installer Parameters

Controller pack
Service Manual
124
Installationcongurationsettings
SMGB0066 rev.0 - 12/2009
Set button
• Usedtoentersettingmode
• Usedtoacceptnewvalueforaparameter.
Info button
• UsedtoenterOperationalDataDisplaymode.
• Usedtoselectnextoperationaldataitem
Pressing particular combinations of these buttons will allow display or alteration of the various operating parameters.

ThecongurationoftheSystemControllerisperformedusingthe5buttonsonthefrontcover.Viathesebuttons,asimple
menustructurecanbeaccessedtoadjustallthecontrollerparameters.
Allmenususethe4charactersintheleftofthedisplaytoshowanabbreviatedname,andthethreedigitsintherightforthe
value. Units are shown in the far right of the display next to the value.
Ifnobuttonispressedfor10minutes,thedisplaywillreturntothedefaultmenu,ortherelevantfaultcode.
 
The System Controller is delivered with a set of pre-programmed parameters to allow a quick start-up procedure. The factory
defaultsettingsareshowninthetableonthenextpage.Shoulditbenecessarytoadjustanyoftheseparametersettings,
please refer to the table and follow the instructions below.
ToenterParameterDisplaymodefromtheNormalOperationmode,press
and buttons together for at least one
second.Thedisplaywillshow“CONF”toindicatethattheSystemControllerisinParameterDisplaymode,andshowsthe
rstparameterCONF(HydraulicConguration)anditscurrentsetting.
Use the 1.
and buttons to move up or down the parameter list according to the table.
Tochangeaparametersetting,usethe2.
SET
buttontoenterParameterSettingmode.Thevalueoftheparameterwillash
to show that it can now be changed. Use the
and buttons to change the value to the desired setting.
Tostoretheparametersetting,pressthe3.
SET
button.Theashingwillstoptoshowthevaluehasbeensaved.Instead,to
cancelthechange,andretainthepreviouslystoredvalue,pressthe
SEL
button.
Continuetochangetheparametersasrequired.Whennished,oratanytime,pressingthe4.
button will return the
display to Normal Operation mode.
Normal Operation mode Output Display mode Output Setting mode
& > 1 sec.
SET
SET
SEL