EasyManua.ls Logo

Hitachi YUTAKI Series - System Configuration, Settings And Control System; Description; System Controller Overview

Hitachi YUTAKI Series
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
73
Systemconguration,settingsandcontrolsystem
SMGB0066 rev.0 - 12/2009
Controller pack
Service Manual
4

 
TheSystemControllerisacongurableoutdoor-temperature-compensatedheatingcontroller.
The System Controller is a part of the Heat Pump Controller Pack and is linked to the other components of the hydronic
controlsystem,suchasthewirelessRoomUnit,RFReceiver,WaterTemperatureSensorandOutsideSensor.
TheRoomUnitisconnectedtotheSystemControllerviaradiosignals,enablingsimplerinstallationandofferingtheend
user a choice to operate the system.
TheSystemControlleroperatestheheatpump,electricheaterorboiler,valvesandpumpstoensureoptimaloperationof
the heating system.
TheSystemControllerhasanLCDdisplaywithasimplemenustructureoperatedbyvebuttons,sothatitcaneasilybe
conguredtomanydifferentapplicationswithspecicinstallationsettings.
note
When performing any work with this product (installation, mounting, start-up), all instructions given by the -
manufacturer and in particular the safety instructions provided in the installation instructions must be followed.
The System Controller may only be installed and mounted by authorised and suitably trained personnel. -
If the unit is modied in any way, except by the manufacturer, all warranties concerning operation and safety are -
invalidated.
Make sure that local standards and regulations are respected at all times. -
Use only accessory equipment that comes from or has been approved by Honeywell or Hitachi. -
caution
Electrical hazard. Can cause serious injuries or death. -
Disconnect the mains power supply before the installation of the System Controller. Do not reconnect the -
power supply until all installation work is completed.
Before the controller is dismantled, disconnect the main power supply. -
 
TheSystemControllerisdesignedforcontrollingtheheatpumpinamono-valent,mono-energeticorbi-valentheating
system.Itprovidesefcientcontrolandreducesenergyusewhilemaintainingcomfortinthebuilding.
• Modulatingcontrolofheatpump.
• ControlofanAuxiliaryheatsource(electricheaterorboiler).
• Outsidetemperaturecompensated(OTC)control.
• Controlofheatingcircuitpumps/valvesand,optionally,domestichotwaterstorage.
• Systemfrostprotection.
ThefunctionalityoftheSystemControllerdependsontheinstalledcomponentsandtheselectedconguration.TheSystem
Controllerisdesignedinawaythatitcanbeconguredandupgradedtomeetmanyapplicationrequirements.

Table of Contents

Other manuals for Hitachi YUTAKI Series

Related product manuals