Unit installation
Service Manual
28
Accessories Installation
SMGB0066 rev.0 - 12/2009
Ref. Qty. Name Ref. Qty. Name
1 Tank body
1 PSW
1 Front E-casing
2 3-pole contactor
1 Back E-casing
1 Thermostat
1 Tank in-connection
1 Terminal board
1 Wall support
1 Packing gland
1 Tank front cover
2 Packing gland
1 Tank out-connection
1 PSW protector
1 Resistance
1 Caution label
1 Tank body insulation
1 Indication poster
1 Tank body insulation
1 Wiring label
Transport the products as close as possible to the installation location before unpacking.
Check the contents of the package:
WEH-6E -
Installation and Operation Manual -
(2) M6x15 screw and (2) M6 washers -
Wallxingsupport -
note
WEH appliance must be installed in an indoor place. -
WEH installation must be done by professional installers. -
Install the WEH with sufcient clearance around it for operation and maintenance as shown in the following -
gures.
Install the WEH where good ventilation is available. Do not install the WEH where there is a high level of oil -
mist, salty air or sulphurous atmosphere.
When installing some device next to WEH, keep clearance between WEH and any other obstacle of more than -
500mm.
To Next Page
Loading...
