Hitachi YUTAKI Series - Removing The Electrical-Noise Filter

Servicing
Service Manual
256
RHUE-(3~6)A(V)HN
SMGB0066 rev.0 - 12/2009
 

All RHUE Yutaki units are equiped with electrical-noise
lterPCB.

danger
Electrical hazard. Risk of death. -
Check that the LED201 (red) located on the inverter -
module is OFF when opening the P-mounting plate.
Do not touch the electrical components when LED201 -
(Red) located on the inverter module is ON in order to
avoid an electrical shock.
Disconnect all the wirings (9 in total) connected to the 1.
electrical-noiselter.
Remove the six (6) holders from the PCB. When 2.
reassemblingthecomponents,passthoseholders
again through the holes of the PCB.
6 plastic holders
Extraction of the PCB from the holders