EasyManua.ls Logo

Hitachi YUTAKI Series - Locating the Room Unit; Communication Loss

Hitachi YUTAKI Series
262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
133
System MMI Pack (Room unit and RF receiver)
SMGB0066 rev.0 - 12/2009
Controller pack
Service Manual
4

WhilestillintheTestMode,theRoomUnitshouldbelocatedtakingthefollowingintoconsiderationandreviewingthe
illustrations below:
Find a suitable location where the signal transmission is reliable. Reliable transmission is indicated when the RF 1.
ReceiverisashingthegreenLEDevery6seconds.
Install the 2.  EITHER on the wall using the wall bracket OR attach the optional table stand as shown in below.
Exit the Test Mode by pressing the 3.
or button.
 
• TheRoomUnitshouldbeinstalledinanopenspaceforbestperformanceasitisaradiofrequencydevice.
• Leaveatleast30cmdistancefromanymetalobjectsincludingwallboxesandatleast1meterfromanyother
electricalequipmentasradio,TV,PCetc.
• Donotmountontometalwallboxes.
• ItisrecommendedthattheRFReceiverisfullyinstalled.
 
IntheeventofanRFcommunicationsloss,theLEDontheRFReceiverwillindicatewhichtypeoffaulthasoccurred.
• IfthereisacommunicationsfaultbetweentheRFReceiverandtheRoomUnit,thentheLEDontheRFReceiverwill
ashredfor0.1secONeverythreeseconds.
• IfthereisafaultincommunicationsbetweentheboilerorSystemController,thentheLEDontheRFReceiverwillash
3 times quickly and then be off for three seconds.
• IfthereismorethanoneRoomUnitinstalled,asinmulti-zonesystemsforexample,andcommunicationsislostwithone
zone,thentheredLEDontheRFReceiverwillashtwotimesquicklyandthenbeofffortwoseconds.
• IfthereismorethanoneRoomUnitinstalled,asinmulti-zonesystemsforexample,andcommunicationsislostwith
bothzones,thentheredLEDontheRFReceiverwillashoncefor0.1secON,and0.9secOFF.
Oncethefaultydevicehasbeenidentied,replaceasnecessaryandfollowthere-bindingprocedureasdescribedinsection
Binding / Rebinding Procedure.

Table of Contents

Other manuals for Hitachi YUTAKI Series

Related product manuals