Hitachi YUTAKI Series - Removing Air Outlet Grille; Removing Service Cover; Rhue-(3~6)A(V)Hn

239
RHUE-(3~6)A(V)HN
SMGB0066 rev.0 - 12/2009
Servicing
Service Manual
9

 
Remove the main parts according to the following
procedures.

note
Screws are represented as black points in the gure -
besides.To reassemble, perform the procedures in reverse.
To prevent contamination of the refrigerant with water or -
foreign particles, do not expose open pipes to atmosphere
for long periods.
If necessary, seal pipe ends using caps or tape. -
Removethenine(9)xingscrewsoftheuppercover.1.
Removethefourteen(14)xingscrewsofthefront2.
cover.
Slide the service cover downward and remove it.3.
Pay attention of not falling off the service cover.4.
 
Removetheeight(8)xingscrews.1.
Lift the air outlet grille holding the lower parts.2.
Release the extruded hook of the air outlet grille from 3.
the shroud.
Air outlet
grille
Screws
Screw